Project · Lakewood, Sunnyvale
Lakewood laundry circuits
A laundry room moving from the garage into the house during a remodel. We ran a 30A dryer circuit, a dedicated 20A washer circuit, a 20A GFCI for the counter and a lighting circuit with a fan, all from the panel through the attic while the walls were open.
Circuits4 new
Dryer30A · 10 AWG
On site2 days
InspectionsRough + final
What was included
- 30A dryer circuit, 4-wire, 10 AWG copper
- Dedicated 20A washer receptacle
- 20A GFCI counter circuit
- Lighting circuit, humidity-sensing fan ducted to the roof
- Home runs through the attic, no exterior conduit
- Rough inspection coordinated with the GC’s drywall schedule
“They were in and out between the framer and the drywaller without slowing anyone down.”
§ 02
See how the work progresses.
Eight stages from a similar job, start to finish. Concept imagery.
01 · Existing
02 · Protected
03 · Opened
04 · Old cable out
05 · New home runs
06 · Boxes and devices
07 · Testing
08 · Finished
§ 03
How it ran.
- Day 0
Site walk
Reviewed the GC’s plan, confirmed panel capacity and the attic route.
- Day 1
Rough
Four home runs pulled, boxes set, fan ducted.
- Day 2
Rough inspection
Passed; drywall went up the next morning.
- Week 3
Devices
Receptacles, switches and fan trim after paint. Final passed.
Planning a rewiring or remodel job?
Read the service page or book a walk. Every scope is written the same day.
§ 04
More projects.
Panel · 200A · 4 weeksCherry Chase panel upgradeZinsco out, 200A meter-main in, heat pump ready.
Lighting · 3 layers · 3 daysBirdland kitchen lightingEight cans, three pendants, under-cabinet tape, two scenes.
EV · 48A · Half dayPonderosa EV chargerFull panel, no upgrade: load management did the job.
Outdoor · 14 fixtures · 2 daysHeritage District walkwayPath lights, an up-lit oak, a sunset timer.